1035. Using On-Screen Menu[OPTIONS(2)]Selecting Standby condition in [STANDBY MODE]The projector has two standby modes: [NORMAL] and [NETWORK STANDBY].The [NORMAL] mode is the mode that allows you to put the projector in the power-saving condition which consumesless power than the [NETWORK STANDBY] mode. The projector is preset for the [NORMAL] mode at the factory.NORMAL�����������������������������POWER indicator: Red light/STATUS indicator: OffWhen [NORMAL] is selected, only the following buttons and feature will work:POWER button on the projector cabinet and the remote control, and powering on from PC Controlcommand�NETWORK STANDBY ����������POWER indicator: Orange light/STATUS indicator: OffWhen [NETWORK STANDBY] is selected, the projector can be turned on over a wired LAN connec-tion and only the following buttons, port, and features will work:POWER button on the projector cabinet and the remote control, powering on from PC Controlcommand, AUTO POWER ON(COMP�), LAN port, wireless LAN unit (optional), Virtual Remote Tool,LAN feature, and Mail Alert feature�Important:- When [NETWORK STANDBY] is selected, [AUTO POWER OFF] will turn grey in color and be disabled, and [0:15] will be selectedautomatically.NOTE:• Even when [NORMAL] or [NETWORK STANDBY] is selected for [STANDBY MODE], power on or off can be done by using the PCCONTROL port.• The power consumption in the standby mode will not be included in calculating CO2 emission reduction.• Your setting will not be affected even when [RESET] is done from the menu.Enabling Direct Power On [DIRECT POWER ON]Turns the projector on automatically when the power cord is inserted into an active power outlet. This eliminates theneed to always use the POWER button on the remote control or projector cabinet.
