4-32 System ConfigurationConfiguration SettingsIf you select "Configuration Settings" from the "Fast!UTIL Options" menu, the screen for settingthe configuration appears.Host Adapter SettingsSCSI Device SettingsSCSI Bus SettingsAutoconfigure SCSI DeviceSelectable Boot SettingsRestore Default Adapter SettingsRaw Nvram DataConfiguration SettingsHost Adapter SettingsIf you put the cursor on "Host Adapter Settings" with keyboard cursors (↓ and ↑) in the"Configuration Settings" menu and press Enter, the screen for setting the information on the hostadapter appears.The table below shows the parameters of the setting items and their factory settings.Submenu item Parameter DescriptionBIOS Address - View onlyBIOS Revision - View onlyAdapter Serial Number - View onlyInterrupt level - View onlyHost Adapter BIOS [Enable]DisableSpecify whether the BIOS extension of the hostadapter is enabled or disabled.PCI Bus DMA Burst [Enable]DisableSpecify whether the DMA burst transfer on the PCIbus is enabled or disabled.CDROM Boot Enable[Disable]Specify whether the start from CD-ROM is enabled ordisabled.Adapter Configuration [Auto]ManualSafeSpecify whether the adapter configuration is setautomatically by BIOS, manually, or safely.Drivers Load RISC [Enable]DisableSpecify whether the load of RISC codes is enabled ordisabled.>4GByte Addressing Enable[Disable]Specify whether hard disks of 4 GB or larger is usedor not.Fast Command Porting [Enable]DisableDo not change the factory setting.[ ]: Factory-set
