System Configuration 4-33SCSI Device SettingsIf you put the cursor on "SCSI Device Settings" with keyboard cursors (↓ and ↑) in the"Configuration Settings" menu and press Enter, the screen for setting the information on the deviceconnected to the host adapter appears.The table below shows the parameters of the setting items and their factory settings.IMPORTANT: The settings can be made for each SCSI bus.ParameterSubmenu itemSCSI Bus0 SCSI Bus1DescriptionDisconnects OK [Yes]No*[Yes]NoSpecify whether the disconnection ofSCSI devices from the SCSI bus isenabled or disabled.* On Bus0, select "No" for ID8.Check Parity [Yes]No[Yes]NoSpecify whether the parity check isprovided or not.Enable LUNs [Yes]No[Yes]NoSpecify whether more than one LUNnumbers are given to SCSI ID.Enable PPR [Yes]No[Yes]NoDo not change the factory setting.Enable Device [Yes]No[Yes]NoDo not change the factory setting.Negotiate Wide [Yes]No[Yes]NoSpecify whether the wide (32 bits)transfer is enabled or disabled.NegotiateSynchronous[Yes]No[Yes]NoSpecify whether the synchronoustransfer is enabled or disabled.Tagged Queuing [Yes]No[Yes]NoDo not change the factory setting.Sync Offset 00, 02, 04, 06, 08,10, 12, 14, 16, 18,20, 22, [24]00, 02, 04, 06, [08],10, 12, 14, 16, 18,20, 22, 24Select the proper offset value insynchronous transfer.Transfer Rate(Mbytes/sec)Transfer Rate(Mbytes/sec)[9] 160 (Ultra3SCSI)9 160 (Ultra3SCSI)10 80 (Ultra2SCSI)[10] 80 (Ultra2SCSI)12 40 (UltraSCSI)12 40 (UltraSCSI)25 20 (FastSCSI)25 20 (FastSCSI)Sync Period40 12.5 40 12.5Select the proper speed insynchronous transfer.Exec Throttle 1, 4, 8, [16], 32,64, 128, 2551, 4, 8, [16], 32, 64,128, 255Do not change the factory setting.[ ]: Factory-set
