Chapter 5: Communications 7197 Owner’s GuideFebruary 2002 66Switch SettingsThe DIP switches are located on the PC board at the back of the printer as shown in theillustration in “Level 1 Diagnostics” in chapter 4.The switches are used to put the printer into various modes for printer configuration setup.Use a paper clip or other pointed object to set the switches.1. Set the switches to the desired settings shown in the table.Caution: Do not set switch 1 to On. Setting switch 1 to On puts the printer in level 1diagnostics (setup mode) where other functions and tests can be changed.DIP Switch SettingsSwitch 1SettingSwitch 2 Setting Printer StateOFF (0) OFF (0) On-line Mode (default)ON(1) OFF (0) Diagnostic ModeOFF (0) ON (1)* Flash Download ModeON (1) ON (1) Vendor Adjustment Mode* It is optional to set this switch to ON when reflashing the IPL firmware.Printer End View
