NAD T775 Owner's Manual

Also see for T775: Catalog Datasheet Owner's manual Owner's manual Service manual

NAD T775 Owner's Manual Manual pdf 29 page image

DISPLAY SETUPThe Vacuum Fluorescent Display (VFD) and On-Screen Display (OSD) can be shown in various ways bynavigating through the parameters at the ‘Display Setup’ menu. Use a combination of or ENTER andkeys to step through the ‘Display Setup’ menu items.NOTEThe configurations set forth at ‘Display Setup’ are carried over whenever it is enabled during A/VPreset setting. Please see also the section below about ‘AV Presets.’VACUUM FLUORESCENT DISPLAY (VFD)Display : Select ‘On’ to display all applicable data or characters at the VFD. Nothing will be shown atVFD if ‘Temp’ is selected. At ‘Temp’ setting however, whenever any of the front panel controls or theircorresponding keys in the remote control is activated, the appropriate VFD characters will be showntemporarily and then fade away. Note that if any of the Zones are at powered state, they will becontinually shown at VFD even at ‘Temp’ setting.Dimmer : If it is desired to reduce the brightness of the VFD, set Dimmer to ‘Dim’. Otherwise, select‘Bright’ to return to normal VFD brightness.Line 1, Line 2 : The VFD shows two main lines of data or characters. Line 2 is the line of data orcharacters located at the lower bottom of the VFD while directly above it is Line 1. For both lines, onecan select which display could be shown by choosing through the followingMain Source : Shows the active Source.Volume : Current Volume level is shown.Listening Mode : Selected Listening Mode is shown.Audio Src Format : Shows the active Source’s detected audio format.Zone 2-Zone 3-Zone 4 Source : The assigned Source for the applicable Zone is shown.Off : Select ‘Off’ if it is desired not to show any data at the applicable Line.Temp Line : Choose between Line 1 and Line 2 as the desired line where VFD will be temporarilyshown if ‘Temp’ is selected at ‘Display’ option as described above.ON-SCREEN DISPLAY (OSD)Temp Disp : This applies to the OSD that is temporarily shown at video out whenever any of the frontpanel controls or their corresponding keys in the remote control is activated. Set to ‘On’ if it is desired toshow the applicable OSD at the monitor/TV; otherwise, select ‘Off.’OPERATIONUSING THE T 775 – SETUP MENUENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ