NAD T775 Owner's Manual

Also see for T775: Catalog Datasheet Owner's manual Owner's manual Service manual

NAD T775 Owner's Manual Manual pdf 25 page image

ZONE SETUPThe Zone feature allows one to simultaneously experience in different zones of the house multiplesound and applicable video sources from all enabled Sources as well as from Front Input, Media Playerand Tuner.The T 775 has three configurable Zones – Zone 2, Zone 3 and Zone 4. Use a combination of orENTER and keys to navigate through the Zone Setup menu parameters.VOLUMEZone 2 have Fixed and Variable volume control. When set to ‘Variable,’ the Zone 2 Volume is directlyadjustable using cursor keys of the HTR 3 or Volume keys of ZR 4.On the other hand, if Volume is set to ‘Fixed,’ the Zone 2 Volume is set to a preset dB level and thereafterthe Zone’s volume can be varied via the volume control of the separate amplifier it is fed into.MODEZone 3 and Zone 4 can be configured into two modes – Record Out and Zone (Audio Only). If theselected mode is Record Out, the audio and applicable video signal of the assigned Source are directlysent out to the applicable Audio/Video Output (See Item 4. AUDIO 3 OUT/VIDEO 3 OUT, AUDIO 4OUT/VIDEO 4 OUT of REAR PANEL discussion.) When Zone 3 or Zone 4 is set to ‘Record Out’ mode, theywill not be available at the ‘Zone Controls’ section of the Main Menu window.‘Record Out’ setting is ideal for making recordings with a VCR or other similar devices. This setting isalso used for multi-zone installations using passive ‘impedance matching’ volume controls. See yourNAD dealer for specific information about integrating your NAD Receiver into a multi-room audiodistribution system.Zone 2 and Zone 3 ‘Volume’ will function the same way as that of Zone 2 when ‘Mode’ is set to ‘Zone(Audio Only).’See discussion also on ‘Zone Controls’ at the Setup Menu.NOTEThe ZR 4 remote control will only control Zone 2 applications.AMPLIFIER SETUPIf the surround back speakers are not used in the main zone, their surround back amplifier channelscould be assigned for Main back, Main Front (Bi-Amp) and multi-zone use.The Surround Back amplifier is configurable through the following settings• Main Back: Assign as surround back speakers.• Main Front (Bi-Amp): Provide a bi-amp mode for the Main Front speakers (Left and Right)speakers thus reproducing the Front Left and Front Right amplifier channel outputs.• Zone 2: Assign the surround back amplifier channels to supply Zone 2 speaker level outputs fromthe surround back speaker terminals.• Zone 3: Assign the surround back amplifier channels to supply Zone 3 speaker level outputs fromthe surround back speaker terminals.• Zone 4: Assign the surround back amplifier channels to supply Zone 4 speaker level outputs fromthe surround back speaker terminals.OPERATIONUSING THE T 775 – SETUP MENU5ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ