NAD T 787 Owner's Manual

Also see for T 187: Owner's manual Service manual

NAD T 787 Owner's Manual Manual pdf 44 page image

SUMMARY OF THE HTR 8 MODESMode Keys To Press (for 3 seconds)Learn/Copy/Punch Through Device Key + RES KeyDelete Mode Device Key + RTN KeyMacro Record Macro Key + Function KeyLibrary Mode Device Key + [A/V PSET] KeyBack Light Timeout DISP Key + Digit KeyFactory Reset See “Factory Reset” aboveSLEEP MODEThe Sleep Mode timer will switch the T 787 to Standby mode automaticallyafter a preset number of minutes. Pressing the HTR 8’s SLEEP button once willdisplay the setting of the sleep time increment. Pressing the HTR 8’s SLEEPbutton a second time within a 3-second period will change the sleep timeincrement in 15-minute intervals, after which time the T 787 will automaticallyswitch into Standby mode.To adjust the sleep delay, press the HTR 8’s SLEEP button twice; first todisplay the sleep time increment, and a second time to change thesleep time increment. The sleep time increment and a “SLEEP” icon willcontinuously display on the T 787’s front panel Vacuum Fluorescent Display(VFD). Each consecutive press increases the sleep time in 15-minuteincrements from 15 to 90 minutes. To cancel the sleep mode, continuepressing the HTR 8’s SLEEP button until “Sleep Off” displays on the VFD.Switching the T 787 to standby from either the HTR 8’s OFF or the T 787’sSTANDBY button will also cancel the sleep modeUSING THE ZR 7 REMOTE CONTROLThe ZR 7 is a discrete compact remote for controlling the Zone 2 feature of theT 787. Irrespective of the main room/zone settings, the ZR 7 allows full separatecontrol of the Zone 2 source selection among other applicable features.1 ON/OFF: Switch ON/OFF the Zone feature.2 SOURCE [ d/f ]: Select the active input of the NAD T 787 that will besent out to the corresponding rear panel ZONE 2 output port.3 MUTE: Temporarily switch OFF or restore the Zone Volume level.4 VOLUME [ d/f ]: Increase or decrease the loudness level of selectedZone source. This is possible only if the VOLUME setting of ZONE 2CONTROLS is set to VARIABLE.5 PRESET [ a/s ]: Step up or down between stored radio presets. Thiscontrol button is possible if the selected Zone is “TUNER” and the activetuner section has stored presets. This control button is not applicable toT 787.6 The following CD Player Zone buttons can control a compatible CDPlayer. The CD Player has to be powered ON and disc loaded.SKIP [ 0 ]: Go to the beginning of a track/file or previous track/file.SKIP [ 9 ]: Go to the next track/file.[ 4 ]: Start playback.NOTEThe ZR 7 remote control will only control Zone 2 applications. Zone 3and Zone 4 could be configured and managed at the appropriateZone OSD menu using the front panel navigations keys as well as thecorresponding keys on the HTR 8 remote control. The HTR 8’s ‘CUSTOM’device is also defaulted to Zone 2 remote control codes.OPERATIONUSING THE HTR 8 REMOTE CONTROL44ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ