NAD T 787 Owner's Manual

Also see for T 187: Owner's manual Service manual

NAD T 787 Owner's Manual Manual pdf 39 page image

NAD IPD 2The NAD IPD 2 has its own remote control - the DR 1. When using the DR 1to command your iPod player docked in the NAD IPD 2, you have to refer toyour iPod player’s own display screen to make full use of its feature; there isno OSD at this condition. However, any time you press HTR 8’s [ S ] buttonor [ s ] on the front panel, the “Menu Select” OSD comes up. If you select“iPod Menu” at this “Menu Select” option, the NAD IPD 2 gets manuallyconnected. The control of the NAD IPD 2 will then again be done throughthe T 787 using the applicable front panel control buttons or HTR 8 buttonswhile referring to the OSD; the NAD IPD 2 will not respond to any DR 1commands at this stage.IMPORTANT NOTES• For you to control the NAD IPD 2 using the DR 1, you have to go to “iPodSetup” menu (please refer to the item about “iPod Setup” under the“USING THE T 787 - SETUP MENU” segment of OPERATION section) andthen set “Auto Connect” to “No”. With this setting, you can then use theDR 1 to control your iPod player docked in the NAD IPD 2.• Note that if you set “Auto Connect” to “No” while at Source 5 (iPod),you have to change source and then return to Source 5 (iPod) for thechanged setting to take effect.REGAIN CONTROL OF NAD IPD 2 USING DR 1 REMOTE CONTROLIn order to switch back control of the NAD IPD 2 from the T 787/HTR 8 tothe DR 1 remote control, follow these steps.1 Exit from the iPod Menu by pressing repeatedly [ A ] until it brings youto “Menu Select” OSD.2 Highlight “iPod Menu” and press [ A ] to advance to “iPod Menu”.3 At “iPod Menu”, press [ S ] to close iPod menu. DR 1 remote controlregains control of the NAD IPD 2.In addition to the above commands common to the DR 1, below are thedescriptions of the other DR 1 control buttons.LIGHTPress [LIGHT] to turn ON the backlight of your iPod player if it is at idlemode.MENUPress [MENU] to return to previous option or menu selectionENTERPress [ENTER] to select an option or start playback.m (REPEAT)Toggle to initiate repeat mode as follows - repeat one song, repeat all songsor cancel repeat mode, (RANDOM)Toggle to initiate playback in random order. There are three random modes- Shuffle Song, Shuffle Album or Shuffle Off.9/0• During playback mode, press [0] to skip forward to the next song or[9] to skip back to the previous song.• During playback or pause mode, press and hold [9/0] for fastforward or backward scanning of current song. Release [9/0] toresume playback.TO VIEW VIDEOS OR PHOTOS LOADED IN YOUR iPodVideos or photos uploaded in your iPod can be viewed directly via theT 787. The following are the steps1 Make sure that the “TV Out” setting of your iPod’s Video Settings menu isat “On” mode and appropriate “TV Signal” is chosen.2 Video or photo file selections and playback procedures are manageddirectly from your iPod player and not through the T 787. You must exitcompletely from the T 787’s Setup Menu or Menu Select OSD for youto be able to navigate through your iPod player’s video or photo menuoptions. A more direct way is by going to the “iPod Setup” menu and set“Enabled” to “No”.3 With the NAD IPD’s S-VIDEO OUT and AUDIO OUT ports connected tothe T 787’s AUDIO 5/S-VIDEO 3 input or to any other assignable input,you can now directly enjoy via T 787 your video or photo file selectionsas uploaded in your iPod. Make sure that you select the correct “SourceNumber” of the T 787. Note that if “Enabled” from “iPod Setup” is setto “No”, ensure that Source 5 is enabled and analog audio and videosettings are assigned to “A5” and “S3” respectively.NOTEFor other navigation functions, please refer to your iPod player’s owner’smanual. Depending on the iPod player model, some other functionsmaybe controlled using the applicable T 787 navigation controls.iPod is a trademark of Apple, Inc., registered in the U.S. and other countries.OPERATIONLISTENING TO YOUR iPod PLAYER39ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ