NAD C165BEE Owner's Manual

Also see for C165BEE: Specifications Owner's manual Service manual

Contents

NAD C165BEE Owner's Manual Manual pdf 12 page image

condition poSSible cauSeS poSSible SolutionSNo sound. Power AC lead unplugged or power notswitched ON.• Check if AC lead is plugged in and powerswitched ON.•Tape Monitor selected.• De-select Tape Monitor mode.•Mute on.• Switch off Mute.•No sound one channel. Balance control not centered.• Center Balance control.•RCA lead to power amplifier not properlyconnected or damaged.• Check leads and connections.•Input lead disconnected or damaged.• Check leads and connections.•No sound from Subwoofer. Subwoofer is off, not powered or improperlyconnected.• Power-up subwoofer, check subwoofer’s ACoutlet or check connections.•Remote control handset not working. Battery flat or incorrectly inserted.• Check or replace battery.•IR transmitter or receiver windows obstructed.• Remove obstruction.•IR receiver in direct sun or very bright ambientlight.• Place unit away from direct sun, reduceamount of ambient light.•PHONO section problems only. No signal.• Check if MC-MM switch is set to the correctinput.•Hum on phono input.• Check if phono earth lead is connected tothe PHONO GROUND connector.•Weak or distorted signal.• Check if the turntable is connected to thecorrect C 165BEE MM or MC phono input.•REFERENCEtroubleShooting1ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

/ 14

Related manuals for NAD C165BEE