NAD C 368 Owner's Manual

Also see for C 368: Quick setup guide Service manual User manual Owner's manual

Contents

NAD C 368 Owner's Manual Manual pdf 5 page image

IDENTIFICATION OF CONTROLSFRONT PANEL1 POWER INDICATOR• This indicator will be amber when the C 368 is in standby mode.• When the C 368 is powered up from standby mode, this indicatorwill change from amber to blue color.2 STANDBY BUTTON• Press Standby button to switch ON the C 368 from standby mode.The Power indicator will change from amber to blue color.• Pressing Standby button again switches back C 368 to standbymode. The Power indicator will change from blue to amber color.• The Standby button cannot activate the C 368 if the rear panelPOWER switch is off.IMPORTANT NOTESFor the Standby button to activate, the following must occur:a The supplied power cord from the C 368 must be plugged in to a powersource.b The rear panel POWER switch must be set to ON.3 NAVIGATION AND ENTER BUTTONS• The navigation [d/f/a/s] and [ENTER] buttons are used to gothrough menu options and selections.• Use [d/f/a/s] to go up, down, left or right given options orselections.• The middle round button is designated as [ENTER] button. This isnormally pressed to complete a selection, procedure, sequence orother applicable functions.4 HEADPHONE• A 1/4” stereo jack socket is supplied for headphone listening andwill work with conventional headphones of any impedance.• The volume, tone and balance controls are operative forheadphone listening. Use a suitable adapter to connectheadphones with other types of sockets, such as 3.5mm “personalstereo” jack plugs.5 DISPLAY• Show visual and menu information according to the selectedsettings.• The following Main menu options are shown in the display - SourceSetup, Settings and BluOS Setup (available if MDC BluOS module isinstalled).Use the SR 9 remote control or front panel navigation [d/f/a/s] and[ENTER] buttons to go through menu options and selections.6 REMOTE SENSOR• Point the SR 9 remote control at the remote sensor and press thebuttons.• Do not expose the remote sensor of the C 368 to a strong lightsource such as direct sunlight or illumination. If you do so, you maynot be able to operate the C 368 with the remote control.Distance: About 23ft (7m) from the front of the remote sensor.Angle: About 30o in each direction of the front of the remote sensor.7 a SOURCE s• Press a SOURCE or SOURCE s to select Sources.8 VOLUME• The VOLUME control adjusts the overall loudness of the signal sentto the loudspeakers. The Volume control is characterized by perfectsignal tracking and channel balance. It provides a highly linear andlow noise operation.• Turn clockwise to increase the volume level and counter clockwiseto lower it.• The default volume level is -20dB.Hybrid Digital DAC Amplifier C 368NA D VOLUMESOURCE© NAD C3687 81 2 3 4 655ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ