Menu
Lenovo s200 Hardware Maintenance Manual
Also see for IdeaPad S200: User guideUser guideNoticeManualUser guide
                                                                                                                                          |
9. Position the new power button board in the power button board holder so that the tab 1 aligns with theslot on the new power button board. Then, press the power button board as shown until it snaps intoposition and is secured by the tab 1 .Figure16. Securing the power button board cable10. Connect the cable of the new power button board to the power button board connector on the systemboard. See “Parts on the system board” on page 34.11. Reinstall the front bezel. See “Replacing the front bezel” on page 83.What to do next:• To work with another piece of hardware, go to the appropriate section.• To complete the installation or replacement, go to “Completing the parts replacement” on page 109.Replacing the computer handleAttention: Do not open your computer or attempt any repair before reading and understanding the Chapter1 “Read this first: Important safety information” on page 1.To replace the computer handle, do the following:1. Remove any media from the drives and turn off all connected devices and the computer. Then,disconnect all power cords from electrical outlets and disconnect all cables that are connected to thecomputer.2. Remove the computer cover. See “Removing the computer cover” on page 82.3. Remove the front bezel. See “Replacing the front bezel” on page 83.4. Remove the power button board. See “Replacing the power button board” on page 85.5. Locate the computer handle. See “Computer components” on page 31.Chapter 9. Installing or replacing hardware 87 |
Related manuals for Lenovo IdeaPad S200
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved