Lenovo ThinkSystem SD530 Manual

Also see for ThinkSystem SN850: Product guide Setup guide Quick start Manual

Network settingsItem Options DescriptionNetwork Interface Port • Dedicated• SharedSelect the System Management Network Interface Port.Dedicated is the default setting.Note: This option is configuration dependent.Shared NIC on 1. ML2 Card2. PHY Card3. Onboard Port 1Select the shared NIC port.Note: This item is only on when network interface port ison Shared, and this option is configuration dependent.Fail-Over Rule • None• Failover to shared(Optional CardML2)• Failover to shared(Optional CardPHY)• Failover to shared(Onboard Port)Setting to control Fail-Over types allowed. None is thedefault setting.Note: This item is only on when network interface port ison Shared, and this option is configuration dependent.Burned-in MAC Address N/AHostname N/A Change the host name. The new name should be within 1to 63 characters.DHCP Control • Static IP• DHCP Enabled• DHCP withFallbackConfigure DHCP Control or manually configure a static IPaddress. Fallback will use static IP address if DHCP fails.Select Static to enter IPV4 address manually. DHCP withFallback is the default setting.IP Address x.x.x.x Enter IP address in dotted-decimal notation.When entering an invalid IP address:• ERROR• Invalid Input Range• OkSubnet Mask x.x.x.x Enter Subnet Mask in dotted-decimal notation.When entering an invalid IP address:• ERROR• Invalid Input Range• OkDefault Gateway x.x.x.x Enter Default Gateway in dotted-decimal notation.When entering an invalid IP address:• ERROR• Invalid Input Range• OkIP6 • Enable• DisableEnable/Disable IPv6 support on management port.Enable is the default setting.Chapter 3. System configuration and boot management 47