Lenovo ThinkSystem SD530 Manual

Also see for ThinkSystem SN850: Product guide Setup guide Quick start Manual

SP Redirection • Enable• DisableThis option is only displayed while “Console Redirection”,“COM Port 1” and “COM Port 2” set to [Enable]. It allowsyou to choose which COM port to have the redirection.Note: Only show when set Console Redirection toEnable.Disable is the default setting.Legacy OS/Option ROMDisplay • COM Port 2• COM Port 1Select a COM port to display redirection of Legacy OSand Legacy OPROM Messages.COM Port 1 is the default setting.COM1 Settings N/A Settings required for serial connections used forasynchronous start-stop communication.COM1 Baud Rate • 115200• 57600• 38400• 19200• 9600Control the connection speed between the host andremote system. 115200 is the default setting.COM1 Data Bits • 8• 7Set the number of Data bits in each character.COM1 Parity • None• Odd• EvenSelect parity bit in each character to be [None], [Odd], or[Even]. [None] means that no parity bit is sent at all. Noneis the default setting.COM1 Stop Bits • 2• 1Set Stop Bits. Stop Bits sent at the end of every characterallow the signal receiver to detect the end of a characterand to resynchronize with the character stream.COM1 Terminal Emulation • VT100• VT-UTF8• ANSISelect [VT100] only if the remote emulator does notsupport ANSI text graphics. Consult the emulatordocumentation for more information. ANSI is the defaultsetting.COM1 Active After Boot • Enable• DisableWhen [Disable] is selected, then Legacy ConsoleRedirection is disabled before booting to legacy OS.When [Enable] is selected, then Legacy ConsoleRedirection is enabled for legacy OS. "COM1 Active afterBoot" and "COM2 Active after Boot" settings go together,and if you change one setting, it automatically changesthe other. Disable is the default setting.COM1 Flow Control • Disable• HardwareSelect [Hardware] only if the remote emulator support andis using hardware flow control. Consult the emulatordocumentation for more information. Disable is thedefault setting.COM2 Settings N/A Settings required for serial connections used forasynchronous start-stop communication.14 ThinkSystem Server with Intel Xeon SP (1st, 2nd Gen) UEFI Manual