5. Turn on your computer, and then press and hold the 'F1' key until the "BIOS Utility"menu appears.6. If the computer presents a password prompt type in the correct password.7. Select 'Load Default Settings' and then press “Enter”.7. Select 'Yes' and then press “Enter”.8. Press “Esc”, then select 'Yes'. Press “Enter” to restart computer.Section 4: Using the System Program Service Diskette for ThinkPad 240, 570, and 570EmodelsAfter creating the System Program Service Diskette, please follow these instructions:1. It is recommended to print the instructions that accompany the System Program ServiceDiskette.2. Firmly connect the AC adapter to the computer.3. Insert the System Program Service Diskette into the diskette drive, then turn on thecomputer.4. Select "Read this first..." from the menu and carefully read the information that appears.5. Press ‘Esc’ to return to the menu.6. Select "Update system program" by using the arrow key and press ‘ENTER’. Follow theinstructions on the screen.Warning: Do not turn off your computer until the update has completed. IF YOU TURNOFF YOUR COMPUTER WHILE THE UPDATE IS STILL IN PROGRESS, THESYSTEM BOARD MIGHT HAVE TO BE REPLACED.After the BIOS update, perform these steps to make the changes effective:7. Turn on your computer, then press the 'F1' key to enter the "IBM BIOS Setup Utility".8. If the computer presents a password prompt, type in the correct password.9. Press the 'F9' key. Select [Yes] in the “Setup Confirmation" screen to load the defaultconfiguration.10. Press the 'F10' key. Select [Yes] in the "Setup Confirmation" screen to save configurationchanges then exit the “IBM BIOS Setup Utility”.
