Lenovo 5468 Setup Manual

Also see for 5468: Quick start Manual

Contents

Chapter 4. System configurationComplete these procedures to configure your system.Notes: The minimum supported configuration for this server is as follows:• One n1200 Enclosure• One SD650 Dual Node DWC Tray (contains two computer nodes)• One processor on location 1 on specific node• One CFF v2 power supply (any type)• One DIMM (any type) on specific node• One disk (any type) (If OS is needed for debugging)Set the network connection for the Lenovo XClarity ControllerBefore you can access the Lenovo XClarity Controller over your network, you need to specify how LenovoXClarity Controller will connect to the network. Depending on how the network connection is implemented,you might need to specify a static IP address as well.The following methods are available to set the network connection for the Lenovo XClarity Controller if youare not using DHCP:• If a monitor is attached to the server, you can use Lenovo XClarity Controller to set the networkconnection.• If you are using the Lenovo XClarity Administrator Mobile app from a mobile device, you can connect tothe Lenovo XClarity Controller through the Lenovo XClarity Controller micro-USB connector on the front ofthe server. For the location of the Lenovo XClarity Controller USB connector, see “Front view” on page 17.To connect using the Lenovo XClarity Administrator Mobile app:1. Connect the USB cable of your mobile device to the Lenovo XClarity Administrator USB connector onthe front panel.2. On your mobile device, enable USB tethering.3. On your mobile device, launch the Lenovo XClarity Administrator mobile app.4. If automatic discovery is disabled, click Discovery on the USB Discovery page to connect to theLenovo XClarity Controller.For more information about using the Lenovo XClarity Administrator Mobile app, see:http://sysmgt.lenovofiles.com/help/topic/com.lenovo.lxca.doc/lxca_usemobileapp.htmlImportant: The Lenovo XClarity Controller is set initially with a user name of USERID and password ofPASSW0RD (with a zero, not the letter O). This default user setting has Supervisor access. Change this username and password during your initial configuration for enhanced security.Complete the following steps to connect the Lenovo XClarity Controller to the network using the LenovoXClarity Provisioning Manager.Step 1. Start the server.Step 2. When you see Setup, press F1.Step 3. Specify how the Lenovo XClarity Controller will connect to the network.© Copyright Lenovo 2018 67