8163A/B, 8164A/B, 8166A/B User’s Guide 395Error Messages 14Return Loss Meterserror message E10010: Invalid Caldatadescription The Caldata loaded on the module is invalid. Either the caldata version number is notcompatible with the firmware or the caldata is corrupt (checksum incorrect)test value (no parameter)action Please return the unit to your local service center for repairerror message E10012: Dual ported RAM write/read test faileddescription Writing bit patterns and reading them back to/from the dual ported ram failedtest value (no test value)action Please return the unit to your local service center for repairerror message E10013: FPGA not correctly initializeddescription Loading the FPGA with data failed. This indicates a defective FPGA or an FPGA accessproblemtest value (no test value)action Please return the unit to your local service center for repairerror message E10014: Firmware corrupt, checksum error (a,b)description Firmware in flash has an invalid checksum. Either the image which was programmed wascorrupt or the flash memory has a failuretest value a is the stored checksumb is the calculated checksumaction Reload the module firmware. If the failure persists, please return the unit to your localservice center for repair
