14Maintenance InstructionsWARNING! Before performing any maintenance to your treadmill, always unplugthe power cord from the surge protector.CLEANINGRoutine cleaning of your Keys Fitness treadmill will extend the life of your treadmill. WARNING! To prevent electricalshock, be sure the power to the treadmill is OFF and the unit unplugged from the wall electrical outlet beforeattempting any cleaning or maintenance.AFTER EACH WORKOUT: Wipe off the console and other treadmill surfaces with a clean, water dampened softcloth to remove excess perspiration. USE NO CHEMICALS.WEEKLY: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt andeventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.DECK LUBRICATIONThe treadmill deck and belt have been pre-lubricated at the factory. However, it is recommended that the walkingboard be checked periodically for lubrication to ensure optimal treadmill performance.Every 30 days or 30 hours of operation, lift the sides of the walking belt and feel the top surface of the walking boardas far under as you can reach. If you feel signs of silicone, no further lubrication is required. If it feels dry to thetouch, follow the instructions below.Please use Lube ‘N Walk or silicone spray such as Napa 8300. (Ask your treadmill dealer or call us)TO APPLY LUBRICANT TO THE WALKING BOARD1) Position the walking belt so that the seam is located on top and in the center of the center of the walking board.2) Insert the spray nozzle into the spray head of the lubricant can.3) While lifting the side of the walking belt, position the spray nozzle between the walking belt and the boardapproximately 6” from the front of the treadmill. Apply the silicone spray to the walking board, moving from the frontof the treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 4 seconds on each side.4) Allow the silicone to ‘set’ for one minute before using the treadmill.WARNING: Do not overlubricate the walking board. Excess lubricant should be wiped off with a clean towel.