Kenmore 665.72002 Use And Care Manual

Also see for 665.72002: Use & care guide Use & care guide Use & care guide

Kenmore 665.72002 Use And Care Manual Manual pdf 24 page image

TROUBLESHOOTING Surface burner makes popping noisesTry the solutions suggested here first in order to avoid thecost of an unnecessar_ service call.Nothing will operate• Is the power outlet properny wired and polarized?Try another outlet to check for proper wiring and polarity• Is the power supply cord unplugged?Plug into a erooerly grounded 3 prong outletIs the burner wet?Let it dryExcessive heat around cookware on cooktopIs the cookware the proper size?Use cookware about the same size as the surface cookingarea element or surface burner. Cookware should not extencmore than 1 in. r2.5 cm) outside the cooking areabreaker been tripped?Replace the fuse or reset the circuit.Oven will not operateHas a household fuse been blown or has the circuit• Is the power outlet properly wired and polarized?Try another outlet to check for proper wiring and polarity.Is the main or regulator gas shutoff valve in the offposition?See installation instructions.• Is the range properly connected to the gas supply?Contact a Sears trained repair specialist or see InstallationInstructions.Surface burners will not operate• Is this the first time the surface burners have been used?Turn on any one of the surface burner knobs to release air"-am the gas lines.• On some models, is the Cooktop Lockout set?See "Cooktop Lockout" section• Is the control knob set correctly?Push in knob before turning to a se[eng.• Are the burner ports clogged?See "Sealed Surface Burners" secuon• Is this the first time the oven has been used?Turn any one of the surface burner knobs on to release a_rffom the gas lines• Is the electronic oven control set correctly?See "Electronic Oven Control" section.• On some models, is the Oven Lockout set?See "Oven Lockout" sectionOven burner fails to light• A household fuse has blown or a circuit breaker has beenmppea• The ignition system is broken. Contact a Sears trained repairtechnician See back cover,Oven makes muffled ticking noise when in use• This is normal and occurs when the oven burner cycles onand off to hold the set oven [emoera[ureSurface burner flames are uneven, yellow and/or noisy• Are the burner ports clogged?See "Sealed Surface Burners" section• Are the burner caps positioned properly?See "Sealed Surface Burners" section• Is the burner damaged?On models with caps, look for a warped cap. If cap will spinOven burner lights, then goes out after 1 minute• Press OFF/CANCEL then wait 1 minute before trying again.• Is the power outlet properly wired and polarized?Try another outlet to check for aroper winng and polarity,Oven burner flames are yellow or noisyfreely on a flat surface painted side down, the cad is waroee,Switch CaD with a different surface burner to check for furtherwarping. Contact a Sears trained repair specialist. See backcover.Is propane gas being used?The appliance may nave been converted improperlyContact a Sears trained repair specialist. See back cover• Is propane gas being used?The appliance may have been converted improperly. Contacta Sears trained repa=r specialist. See back cover.Oven temperature too high or too lowDoes the oven temperature calibration need adjustment?See "Oven Temperature Control" section.24