Section 6: Reading buffers Series 3700A System Switch/Multimeter Reference Manual6-2 3700AS-901-01 Rev. D/June 2018You cannot use top-level command names and reserved words as buffer names. These names arelisted in the following table.Top level command namesand function resetbeeper gettimezone returnbit gpib scanbreak if schedulechannel in scriptcomm io settimedataqueue lan settimezonedelay local setupdigio localnode slotdisplay makegetter statusdmm makesetter thendo memory timerelse nil triggerelseif not trueend opc tsplinkerrorqueue or tspneteventlog os untilexit print upgradefalse printbuffer userstringfor printnumber waitcompleteformat ptp whilefs repeatThe various instrument operations, including buffer operation, are performed on the input signal in apredetermined order. For example, if both REL and MXB (a math operation) are enabled, the RELoperation is always done before MXB.Front-panel buffer operationIn the following procedures, pressing in the navigation wheel will perform the same function aspressing the ENTER key. Also, you can turn the navigation wheel instead of using the CURSORkeys.Read Creating and selecting a reading buffer (on page 6-3) or Selecting a reading buffer (on page 6-3) before performing the following procedures:• Storing readings (on page 6-3)• Saving readings (on page 6-4)• Clearing readings (on page 6-4)• Deleting a reading buffer (on page 6-4)• Recalling readings (on page 6-5)• Buffer configuration (front panel) (on page 6-6)• Appending readings (on page 6-6)
