Kane KM9106 Operator's Manual

Contents

Kane KM9106 Operator's Manual Manual pdf 45 page image

KM9106 Operators Manual428.4.2 Capturing Data From QuintoxTo capture data direct from the Quintox into a PC the RS232 port on the Quintox hasto be connected to the serial port on your PC. Using the standard RS232 lead, andIBM/AT lead if you serial port is a 9 pin D type, connect the Quintox to the PC.The RS232 can output in two formats, Comma Separated variable (CSV) and Binary (forthe logger).The standard default setting is binary and will always be set if the instrument is switchedoff and on. To change between the outputs press followed by .The instrument will beep and change the output, repeat the key sequence to change back.The format for the CSV output is as follows:-Time Date Instability Battery Sensor Ambient Pressure Fuel16:28:30 20-05-96 0 49 23.5 24.5 0.3 12K1g K1n K2 K3 K4 O2 Reference Nett temp Fluetemp0.35 0.39 11.8 9.8 32 3 120 144Inlet temp OxygenreadingExcessairCOReadingCalculation Efficiency Losses DrylossN 8.3 28 55 3.5 83 17 8WetlossCOLossNO NO2 NOx SO2 H2xc Aux1 Aux27 2 20 N 21 N 12 N NThe output will be as the example below:-16:28:30, 20-05-96, 0, 49, 23.5, 24.5, 0.3, 12, 0.35, 00.39, 11.8, 9.8, 32, 3, 120, 144, N,8.3, 28, 55, 3.5, 83, 17, 8, 7, 2, 20, N, 21, N, 212, N, NWhere a number is not displayed the following meanings can be taken:-N = Not fittedF = FaultO = Over range (i.e. Oxygen reading 20.9% hence excess air can not be calculated)8.4.3 Downloading Logged DataThe FIREWORKS software allows data to be downloaded from the handset. Thissection is supplied to explain how to set the handset in a state ready to transmit data.Using the lead RE5PC supplied with FIREWORKS connect the 15 pin D connector tothe handset and the 9 pin D connector to your PC serial port. Most PCs have a 9 pin Dserial port if yours has a 25 pin contact your computer supplier for a convertor.Set the logger to DOWNLOAD data and ensure it is in READY mode.NOTE: You will require batteries to run the logger and download the data.SET/CALENTER AUX