Kane Hawk5000 Operator's Manual

Contents

Kane Hawk5000 Operator's Manual Manual pdf 5 page image

HAWK 5000 OPERATOR MANUALKANE INTERNATIONAL LIMITED 5Range of measurements...HAWK5000 is capable of measuring any or all of the following:Current x 3 phasesPower x 3 phasesVA x 3 phasesTotal Reactive power x 3 phasesLagging reactive power x 3 phasesPulses x 2Voltage x 1Frequency x 1REQUIREMENTSSince the HAWK makes its voltage measurement from the mains input power source, it mustbe powered from one of the three phases it is to measure, or, in the case of high voltagesystems, the output of a voltage step-down transformer which is fed from one of the threephases being measured.SAFETYThis equipment must only be used by trained and competent personnel after dueconsideration of all potential hazards.This equipment must be earthed.CTs should not be used on bare uninsulated live conductors unless they carry theappropriate rating and are labelled accordingly.The Hawk5000 itself is designated:Class 1Installation Category: IIPollution Degree: 2Working Voltage: 260V max.