Menu
KBC WESII-KT User Manual
                                                | |
Contents
| 
WESII User ManualManual-WESII-Rev1205ACopyright © KBC Networks 2012 Page 43 of 48 www.kbcnetworks.com6.3 Industry Canada RestrictionsIC ID# 7849A-N523ESDThis device is in compliance with the applicable sections of the Industry Canada RSS-210 Spectrum Management and Telecommunications Radio Standard Specificationthat governs Low Power License-Exempt Radio communication devices. Specifically,the output EIRP of this device relative to antenna gain is factory set to ensurecompliance with section 6.2.2(q1)(iv)(g).In addition, it is noted for all users that high power radars are allocated as primaryusers (meaning they have priority) of the 5250-5350 MHz and 5650-5850 MHzfrequency bands and these radars could cause interference and/or damage to LELANdevices such as are covered by this manual.6.4 CE Regulatory StatementClass B ITE:This is a Class B product. In a domestic environment this product may cause radiointerference in which case the user may be required to take adequate measures.Declaration of Conformity:KBC declares the following:Product Name: WESIIModel No.: 802.11n Station conforms to the following Product Standards:This device complies with the Electromagnetic Compatibility Directive (89/336/EEC)issued by the Commission of the European Community. Compliance with this directiveimplies conformity to the following European Norms (in brackets are the equivalentinternational standards.)Electromagnetic Interference (Conduction and Radiation): EN 55022 (CISPR 22)Electromagnetic Immunity: EN 55024 (IEC61000-4-2, 3, 4, 5, 6, 8, 11)Low Voltage Directive: EN 60 950: 1992+A1: 1993+A2: 1993+A3: 1995+A4:1996+A11: 1997.CE Mark: following the provisions of the EC directive.KBC also declares that:The wireless card in this product complies with the R&TTE Directive (1999/5/EC)issued by the Commission of the European Community. Compliance with this directiveimplies conformity to the following:EMC Standards: CE: EN 300 328-2, EN 300 826 (EN 301 489-17) EN 301 893.Dynamic Frequency Selection (DFS) & Transmit Power Control (TPC):DFS and TPC are requirements of the ETSI standard EN301 893 V1.5.1, the EuropeanUnion’s harmonized radio standard for unlicensed devices operating in the 5150 –5350 MHz and 5470 – 5725 MHz frequency bands. Radar detection is required whenoperating on channels whose nominal bandwidth falls partly or completely within thefrequency ranges 5250 MHz to 5350 MHz or 5470 MHz to 5725 MHz. In additiondevices using the 5600 – 5650 MHz band are subject to a 10 minute ChannelAvailability Check (CAC). The following table shows how this can affect connectiontimes for certain frequencies: |
Related manuals for KBC WESII-AA
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved