Kärcher K 6.200 Service Manual

Also see for K 6.200: Manual Original instructions

Kärcher K 6.200 Service Manual Manual pdf 22 page image

22 English 5.906-591.0 Rev. 00 (01/14) ADVR Uninstall / install valve for detergent1 O rings2 Water pipes3 Safety clip4 Holder capacitor Remove the pump motor from the chassis. Unhook the holder of the capacitor. Pull out the safety clip. Pull out the water pipes.1 Screws2 Valve gear casing3 Cylinder head4 Piston guide5 O ring6 Retaining clip7 Pin Unscrew the screws. Carefully pull the holding clamps outwards. Remove valve gear casing with cylinder head. Remove the piston guide and the piston.NoteCheck O-rings for damage.Clean the intake and sealing areas.Pay attention to the correct fitting position during reinstal-lation.1 Cylinder head2 O rings3 Control valve4 Injector nozzle Disconnect the cylinder head from the valve gear cas-ing.NoteCheck O-rings for damage.Clean the intake and sealing areas.Check control valve and injector nozzle for ease of move-ment, clean if necessary.Pay attention to the correct fitting position during reinstal-lation.AEZK Uninstall / install cylinder headTorques NmScrews 7,5...9,5