JVC RX-D302BC Instructions Manual

Also see for RX-D301S: Instructions Instructions Instructions Instructions Service manual

15EnglishSelecting the digital decode modeIf the following symptoms occur while playing Dolby Digital or DTSsoftware with “DGTL AUTO” selected (see page 14), follow theprocedure below:• Sound does not come out at the beginning of playback.• Noise comes out while searching for or skipping chapters ortracks.From the remote control ONLY:Press DECODE MODE to select “DOLBYDIGITAL” or “DTS.”• Each time you press DECODE MODE, the digital decode modechanges as follows:• To play back software encoded with Dolby Digital, select“DOLBY DIGITAL.”• To play back software encoded with DTS, select “DTS.”NOTE“DOLBY DIGITAL” or “DTS” is automatically reset to “DGTL AUTO”in the following cases:- When you turn off the receiver.- When you select another source.- When you select “DGTL AUTO” again by pressing ANALOG/DIGITAL.The following digital signal format indicators on the displayindicate what type of signal comes into the receiver.LINEAR PCM: Lights up when Linear PCM signal comes in.: • Lights up when Dolby Digital signal comesin.• Flashes when “DOLBY DIGITAL” is selectedfor any software other than Dolby Digital.: • Lights up when conventional DTS signalcomes in.• Flashes when “DTS” is selected for anysoftware other than DTS.96/24: Lights up when DTS 96/24 signal comes in.NOTEWhen “DGTL AUTO” cannot recognize the incoming signal, nodigital signal format indicator lights up on the display.Turning off the sounds temporarilyFrom the remote control ONLY:Press MUTING to turn off the sound through allconnected speakers and headphones.“MUTING” appears on the display and the volume turns off.To restore the sound, press MUTING again.• Pressing VOLUME +/– (or turning MASTER VOLUME controlon the front panel) also restores the sound.3 Adjust the volumeTo increase the volume, turn MASTER VOLUMEcontrol clockwise (or press VOLUME + on theremote control).To decrease the volume, turn MASTER VOLUMEcontrol counterclockwise (or press VOLUME – onthe remote control).• When you adjust the volume, the volume level indicationappears on the display for a while.CAUTION:Always set the volume to the minimum before starting anysources. If the volume is set at its high level, the sudden blast ofsound energy can permanently damage your hearing and/or ruinyour speakers.NOTEThe volume level can be adjusted within the range of “0” (minimum)to “50” (maximum).Listening with headphonesYou can enjoy not only stereo software but also multi-channelsoftware through the headphones. (Sounds are down-mixed to thefront channels while playing multi-channel software.)Connect a pair of headphones to the PHONES jack on thefront panel to activate the HEADPHONE mode.The HEADPHONE indicator lights up on the display.• You can also enjoy the Surround/DSP mode through theheadphones—3D HEADPHONE mode. For details, see page30.• Disconnecting a pair of headphones from the PHONES jackcancels the HEADPHONE (or 3D HEADPHONE) mode andactivates the speakers.CAUTION:Be sure to turn down the volume:• Before connecting or putting on headphones, as high volumecan damage both the headphones and your hearing.• Before removing headphones, as high volume may output fromthe speakers.LLS RSS.WFR LFEC RAUTO SURRDIGITALDIGITALDGTL AUTO DOLBY DIGITALDTS (Back to the beginning)LS.WFRRAUTO SURRANALOGLS.WFRRAUTO SURRANALOG