JVC RX-D302BC Instructions Manual

Also see for RX-D301S: Instructions Instructions Instructions Instructions Service manual

12English4. Turn on the receiver, then slide the USB WIRELESSswitch on the rear to “ID LEARNING,” and select thesource as “USB WIRELESS.”When you slide the switch, the lamp in the switch startsflashing.5. Set the volume to minimum.IMPORTANT:Always set volume to “0” when connecting or disconnecting theother equipment.6. Press and hold ID on the transmitter to make a wirelesscommunication with the receiver.When you press and hold the button, the ID lamp on thetransmitter flashes.When the receiver recognizes the transmitter, the lamp on therear of the receiver stops flashing and lights up.7. Slide the switch on the receiver to “ON.”• If you do not, no sound signal is transmitted to the receiver.NOTES• The signal-reachable distance is about 30 m, but it may differdepending on the operating conditions and circumstances.• The PLAYER lamp on the transmitter keeps flashing while theplayback software in your PC is reproducing the sound.• If no signals are transmitted from the transmitter for about 30minutes, the transmitter enters “sleep” mode. The “L” and “R”indicators go off from the display.• Though the transmitter may become hot, it is not a malfunction.2 (For USB TERMINAL)1. Turn on your PC.• If the PC has been turned on, quit all the applications nowrunning.2. Turn on the receiver, and select the source as “USBTERMINAL.”3. Set the volume to minimum.IMPORTANT:Always set volume to “0” when connecting or disconnecting theother equipment.4. Connect the receiver to the PC using a USB cable (notsupplied).• Use “USB series A plug to B plug” cable when connecting.USB ConnectionThis receiver is equipped with a USB terminal on the front paneland a USB WIRELESS ANTENNA terminal on the rear. You canenjoy sound reproduced through your PC with either of thefollowing methods:1 connecting a USB wireless antenna (supplied) to the USBWIRELESS ANTENNA terminal and a USB wirelesstransmitter (supplied) to your PC. (USB WIRELESS)2 connecting your PC to the USB terminal with a USB cable (notsupplied). (USB TERMINAL)When you connect your PC for the first time, follow the procedurebelow.• Remember you cannot send any signal or data to your PC fromthis receiver.• Use USB extension cable (supplied) if it is difficult to connectthe transmitter directly to the USB connector or the transmitterbecomes obstacle to other USB connectors.IMPORTANT:Check if your PC equipped with the CD-ROM drive is running onWindows® 98 SE*, Windows® Me*, Windows® 2000* or Windows®XP* and prepare its CD-ROM.Preparation1 (For USB WIRELESS)Be sure to make this procedure when you use USBWIRELESS for the first time. During the procedure,you need to check whether the lamp on the rear ofthe receiver is lit or not.1. Connect the antenna to the USB WIRELESS ANTENNAterminal on the rear panel.• Tighten the screw with the antenna upright.2. Turn on your PC.• If the PC has been turned on, quit all the applications nowrunning.3. Connect the USB wireless transmitter to the USBconnector of the PC.Before connecting the transmitter to the PC, remove the coverof the transmitter.When you connect the transmitter, the USB drivers areinstalled. The POWER and PLAYER lamp on the transmitterlight up.ANTENNAUSB WIRELESSLEARNINGIDONUSBPCUSB wirelesstransmitter (supplied)USB wirelessantenna(supplied)USB cable(not supplied)PCUSB WIRELESS TRANSMITTERPOWER PLAYERIDUSB WIRELESS TRANSMITTERUSB WIRELESS TRANSMITTERIDCHANNEL POWER PLAYERID