JVC RX-D302BC Instructions Manual

Also see for RX-D301S: Instructions Instructions Instructions Instructions Service manual

14Basic operations 2 Select the source to playOn the front panel:Turn SOURCE SELECTOR until the source nameyou want appears on the display.The source lamp corresponding to the selected source lights inred.• As you turn SOURCE SELECTOR, the source changes asfollows:DVD MULTI: Select the DVD player using the analogdiscrete output mode (5.1-channelreproduction).DVR/DVD (DGTL)*: Select the DVD recorder or DVD player.VCR (DIGITAL)*: Select the VCR.DBS (DIGITAL)*: Select the DBS tuner.TV (DIGITAL)*: Select the TV.USB WIRELESS: Select the PC component using awireless equipment.USB TERMINAL: Select the PC component.FM: Select an FM broadcast.AM: Select an AM broadcast.From the remote control:Press one of the source selecting buttons.• For USB WIRELESS and USB TERMINAL, press USB. Eachtime you press USB, the mode alternates between USBWIRELESS and USB TERMINAL.* Selecting the analog or digital input modeFor a component you have connected using both the analogconnection and the digital connection methods (see pages 7 to 11),you need to select the correct input mode.• You can select the digital input only for sources which you haveselected digital input terminals for. (See “Setting the digital input(DIGITAL IN) terminals—DIGITAL IN 1/2/3” on page 22.)From the remote control ONLY:Press ANALOG/DIGITAL to select the analog ordigital input mode.• Each time you press the button, the input mode alternatesbetween the analog input (“ANALOG”) and the digital input(“DGTL AUTO”). This setting is memorized for each source.DGTL AUTO (DIGITAL AUTO):Select for the digital input mode. Thereceiver automatically detects theincoming signal format, then the digitalsignal format indicator (LINEAR PCM,, , or 96/24) for thedetected signal lights up.ANALOG: Select for the analog input mode. TheANALOG indicator lights up on thedisplay.Initial setting: DGTL AUTONOTES• You cannot select the digital input mode when selecting “DVDMULTI,” “FM,” or “AM” as the source.• The input mode is fixed to “DGTL AUTO” when selecting “USBWIRELESS” or “USB TERMINAL” as the source.Source lamps1 2 34 5 67 8 910 0 101321 Turn on the powerPress STANDBY/ON (or AUDIO on theremote control).The standby lamp goes off and the source lamp of the currentsource lights in red.Current source name appears.To turn off the power (into standby)Press STANDBY/ON (or AUDIO on the remote control)again.The standby lamp lights in red.NOTEA small amount of power is consumed in standby mode. To turnthe power off completely, unplug the AC power cord.LS.WFRRAUTO SURR TUNED STEREO AUTO MUTINGMHzANALOG12 3LS.WFRRAUTO SURR TUNED STEREO AUTO MUTINGMHzANALOGDVR/DVD (DGTL)VCR (DIGITAL) DBS (DIGITAL)TV (DIGITAL)FM AM(Back to the beginning)USB WIRELESSUSB TERMINALDVD MULTI