JVC LVT1321-010C Instructions Manual

36You can use the supplied remote control to operate not onlythis receiver but also other JVC products.• Refer also to the manuals supplied with the other products.– Some JVC VCRs can accept two types of the controlsignals—remote codes “A” and “B.” This remote control canoperate a VCR whose remote control code is set to “A.”– Some JVC DVD recorders can accept four types of the controlsignals. This remote control can operate a DVD recorderwhose remote control code is set to the initial code. Fordetails, refer to the manual supplied with the DVD recorder.• To operate other products, aim the remote control directly at theremote sensor on the target product.7 TVOperating otherJVC productsYou can always perform the following operations:TV : Turn on or off the TV.TV VOL +/–: Adjust the volume on the TV.TV/VIDEO: Change the input mode (either videoinput or TV tuner) on the TV.After pressing TV, you can perform the following operations on theTV.CHANNEL +/–: Change the channel numbers.1 – 9, 0, 100+ (+10): Select the channel numbers.RETURN (10): Switch between the previous channeland the current channel.7 VCRYou can always perform the following operation:VCR : Turn on or off the VCR.After pressing VCR, you can perform the following operations onthe VCR.CHANNEL +/–: Change the channel numbers on theVCR.1 – 9, 0: Select the channel numbers on theVCR.3: Start playback.7: Stop playback.8: Pause playback. To release it, press 3.FF: Fast-wind a tape.REW: Rewind a tape.REC PAUSE: Enter recording pause. To startrecording, press this button then 3.1 2 34 5 67 8 910 0 101 2 34 5 67 8 910 0 10