JVC LVT1321-010C Instructions Manual

24Adjusting the equalization patterns—D EQ 63Hz/250Hz/1kHz/4kHz/16kHzYou can adjust equalization patterns in five frequency bands(center frequency: 63 Hz, 250 Hz, 1 kHz, 4 kHz, 16 kHz) for thefront speakers.• Once you have made an adjustment, it is memorized for eachsource.Adjustable range: –8 (dB) to +8 (dB) (in 2 dB intervals)Initial setting: 0 (dB) for all bands• When adjustment is made, the DIGITAL EQ indicator lights upon the display.If no adjustment is required, set all the frequency bands to“0 (dB).”• The DIGITAL EQ indicator goes off from the display.NOTEWhen “DVD MULTI” is selected as the source, this function is notavailable.From the remote control:Before you start, remember...There is a time limit in doing the following steps. If the setting iscanceled before you finish, start from step1 again.1 Press D. EQ FREQ repeatedly toselect the band you want to adjust.2 Press D. EQ LEVEL + or – to adjustthe equalization pattern of theselected band.3 Repeat steps1 and2 to adjustother bands.Adjusting the speaker output levels• SUBWFR LVL (subwoofer output level),• FRONT L LVL (left front speaker output level),• FRONT R LVL (right front speaker output level),• CENTER LVL (center speaker output level),• SURR L LVL (left surround speaker output level),• SURR R LVL (right surround speaker output level),• S BACK L LVL (left surround back speaker output level),• S BACK R LVL (right surround back speaker output level),You can adjust the speaker output levels.Adjust all the speakers’ output levels so that you can listen to thesounds from all the speakers at the same level.• Once you have made an adjustment, it is memorized for eachsource.Adjustable range: –10 (dB) to +10 (dB) (in 1 step intervals)Initial setting: 0 (dB) for all speakersNOTES• If you have selected “NO” for a speaker (see page 19), theoutput level for the corresponding speaker is not adjustable.• If you have selected “DVD MULTI” as the source, “S BACK LVL,”“S BACK L LVL,” and “S BACK R LVL” are not adjustable.• If you have selected “< 1SPK>” for “S BACK OUT” (see page19), “S BACK LVL” appears instead of “S BACK L LVL” and “SBACK R LVL.”• While using the headphones, you can adjust only the left andright front speakers’ output level.From the remote control:1 Press TEST to check the speakers’ output balance.“TEST: FRONT L” starts flashing on the display, and a testtone comes out of the speakers clockwise.• You can adjust the speaker output levels without the testtone.2 Adjust the speaker output levels.Press the + or – button corresponding to the speakeryou want to adjust.3 Press TEST again to stop the test tone.NOTES• No test tone comes out of the speakers for which thespeaker setting is set to “NO” (see page 19).• No test tone is available when the headphone is in use orwhen “DVD MULTI” is selected as the source.• If you have selected “<1SPK > ” for “S BACK OUT” (seepage 19), press + or – button for L – S. BACK to adjust theoutput level.1 2 34 5 67 8 910 0 1021,31 2 34 5 67 8 910 0 1021