JVC DR-M10SUC Instructions Manual

Also see for DR-M10: Instructions Instructions Instructions Instructions

EN 91REMOTERemote ControlFunctionsRemote 1/2/3/4 Code SwitchingThe Remote is capable of controlling four JVC video unitsindependently. Each of the units can respond to one of fourcodes (1, 2, 3 or 4). The Remote is preset to send 3 code signalsbecause your unit is initially set to respond to 3 code signals.You can easily modify your unit to respond to 1, 2 or 4 codesignals.On the RemoteKeep pressing SET UP down during steps A – B.A Change the remote control code.Press the number key “1” for 1, “2” for 2, “3” for 3 or“4” for 4.B Set the remote control code.Press ENTER to set the code.On the unitC Turn off the unit.Press 1 on the unit.D Display the code.Press 4 on the unit for over 5 seconds while the unit isturned off.● The code currently set appears on the front display panel.E Change the unit’s code.Press 8 on the Remote.● The code currently set on the Remote blinks on the frontdisplay panel for approximately 5 seconds, and is applied tothe unit.NOTE:When “POWER SAVE” is set to “ON” ( pg. 99), it is notpossible to change the remote code.Slide the TV/CABLE/DBS/DVD switch to DVD.CABLE/DBSDVDTVDVDCHTIMERREC LINKPROG/CHECKVCR Plus+NEXTPREVIOUSPAUSERECREC MODE LIVE CHECKSET UP DISPLAY ON SCREEN OPEN/CLOSEAUDIO SUBTITLE ANGLE PROGRESSIVESCANSLOWSLOW PLAY/SELECTSTOP/CLEARNAVIGATIONTOP MENURETURNENTERMENUTV/CBL/DBSSTANDBY/ONTVMUTING TV/VIDEOTV VOLUMEABCJKLGHI MNOTUVPQRS WXYZAUXCANCEL MEMO/MARKDBSDEFENTER8SET UP1 – 41 STANDBY/ONS-VIDEO VIDEO L(MONO)- AUDIO- RDV DV INF1REC MODEPULL - OPEN14