JVC DR-M10SUC Instructions Manual

Also see for DR-M10: Instructions Instructions Instructions Instructions

64 EN TIMER RECORDING (cont.)Manual TimerProgramingYou can program this unit to timer-record as many as8 programs.If you do not know the PlusCode number for the program youwish to record, use the following procedure to set your unit totimer-record the program.A Load a disc.A Press x to open the disc tray.B Place a recordable disc on the disc tray.● For details, refer to “Placing a Disc” ( pg. 11).C Press x to close the disc tray.B Access Program Check screen.C Access the program screen.D Enter the recording date.Press rt repeatedly to set the desired date.● The current date appears on the TV screen. The date you enterappears in its place.E Enter the recording start time.Press w e to select “START”, then press rt repeatedlyto set the desired start time.● Each press of rt advances/goes back the start time in 1-min.increments.● To advance/go back the start time in 30-min. increments, pressand hold rt.Before performing Manual Timer Programing:● Turn on the unit.● Turn on the TV and select the AV mode.● Slide the TV/CABLE/DBS/DVD switch to DVD.● Make sure that the unit’s built-in clock is setproperly.CABLE/DBSDVDTVDVDCHTIMERREC LINKPROG/CHECKVCR Plus+NEXTPREVIOUSPAUSERECREC MODE LIVE CHECKSET UP DISPLAY ON SCREEN OPEN/CLOSEAUDIO SUBTITLE ANGLE PROGRESSIVESCANSLOWSLOW PLAY/SELECTSTOP/CLEARNAVIGATIONTOP MENURETURNENTERMENUTV/CBL/DBSSTANDBY/ONTVMUTING TV/VIDEOTV VOLUMEABCJKLGHI MNOTUVPQRS WXYZAUXCANCEL MEMO/MARKDBSDEFrtweENTERxPROG/CHECK0 – 9#Press PROG/CHECK.● When “PROGRAM FULLDELETE UNWANTED TIMERPROGRAM” appears on theTV screen, you need to cancelsome of the reservedprograms. ( pg. 69)Press rt repeatedly toselect “NEW TIMERPROGRAM”, then pressENTER.