JVC DR-M10 Instructions Manual

Also see for DR-M10: Instructions Instructions Instructions Instructions

Contents

Masterpage:Right-No-HeadingEN 95Filename [DR-M10SE_11Subsidiary.fm]Page 95 February 13, 2004 2:23 pmDISPLAY SET(The boldface settings in the table below indicate the settings at your purchase.)8 SUPERIMPOSEOFFAUTOYou can select the modes of indications superimposed on the TV screen.OFF:To turn off superimposed indications.AUTO:To superimpose operational indications for approximately fiveseconds just after the corresponding operation.NOTES:● When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE”to “OFF” before starting. ( pg. 81, “Edit To Or From Another Recorder”)● When you select “AUTO”, during playback, the operation mode indicators may bedisturbed depending on the type of disc being used.8 GREY BACKOFFONWhen this function is set to “ON”, the TV screen becomes all grey whenreceiving a channel not in use.NOTE:When you want to receive an unstable channel with poor signals, set this function to“OFF”.8 DIMMERBRIGHTDIMMED1DIMMED2OFFYou can change the brightness of the front display panel.BRIGHT:Normally select this.DIMMED1/DIMMED2:To change the brightness level. (Blue lamp on the front display panelbecome dimmer.)OFF:To dim the front display panel. (Blue lamp on the front display panelis turned off.)NOTE:It is impossible to turn off the light of the front display completely. When “BRIGHT” or“DIMMED1” is selected, the brightness level will be same as “DIMMED1” after the unit isturned off. When “DIMMED2” or “OFF” is selected, the brightness level will be same as“DIMMED2” after the unit is turned off.8 POWER SAVEOFFONWhen this function is set to “ON”, you can reduce the power consumptionwhile the unit is turned off.NOTES:● During Power Save mode —— the front display panel will be turned off.— the Just Clock function ( pg. 104) does not work.● Power Save does not work when —— the unit is in the Timer mode.— the unit’s power is turned off after timer-recording or Instant Timer Recording.— the Automatic Satellite Programme Recording mode is engaged. ( pg. 63)— “L-2 SELECT” is set to “DECODER”, “SAT VIDEO” or “SAT S-VIDEO”. ( pg. 83)● It takes some time for the unit to complete initialisation after you turn on unit power,with “WAKE UP” blinking on the front display panel.8 ON SCREEN LANGUAGE This unit offers you the choice to view on-screen messages in 10 differentlanguages. Though Auto Set Up selects the language automatically ( pg. 19),you can change the language setting manually as required.For details, refer to “On-screen Language Set” ( pg. 24).DR-M10SE_11Subsidiary.fm Page 95 Friday, February 13, 2004 2:23 PM