EN 61EDITING● To pause dubbing, press selection keys to select ,then press ENTER. Both the unit and the external DVequipment pause dubbing. Pressing W on the unit also worksthe same way.10 Press selection keys to select , then pressENTER. Then press o. The DV equipment stops.11 Press selection keys to select , then pressENTER.12 Press o twice on the remote control to stop dubbing.● Both the unit and the external DV equipment stop dubbing.NOTES:● Dubbing copyright guarded programs is not possible.● Original DV information such as the recording date and time arenot recorded.● The superimposed indication during the operation or dubbing isnot recorded.● If the dubbing is paused while the channel is set to ADVB, youcannot switch channels.To skip unwanted part of the source picturePress ENTER to stop both equipment, then press selection keysto select .Locate the point where you want to restart dubbing by pressing I,N, or O, then press o.Press selection keys to select , then press ENTER torestart dubbing.When you dub from DV equipment other than acamcorderA Perform step 1 to 4.B Locate the point from where you want to start dubbing,then stop on the DV equipment.● If you pause the DV equipment in this step, a fewsecond’s still picture will be recorded at the beginning ofthe recorded program.C Set the input mode to ADV INPUTB on the DV equipment.● If you select an input mode other than ADV INPUTB,unwanted pictures may be recorded at the beginning ofthe recorded program.D Perform step 9 to 12.