JVC DR-DX5SU Instructions Manual

Also see for DR-DX5SEK: Instructions Service manual

Contents

60 EN EDITINGYou can dub programs from a camcorder or DV equipmentconnected to the unit with a DV cable. The unit’s remote controlallows you the limited control of the connected camcorder or DVequipment functions during dubbing.The following on-screen display for DV dubbing appears whenON SCREEN is pressed while the channel has been set to ADVB.A Remote control switchTo switch between the devices operable by the remote controlunit. The unit is operable when the remote icon ( )displayed faces to the left, while the DV device is operable whenthe remote icon is facing to the right.B Auto capture buttonSelect to start or pause the dubbing. If ENTER is pressed whenthe DV device is in the pause condition, preroll editing* where itis possible to dub with a start time that is highly accurate will beactivated. When the DV device cannot be operated from the unit(such as in camera mode), proceed with normal recording(A pg. 34, 37).● Do not start dubbing at the portion with no time code (A– –:– –:– –B).* Preroll editing refers to the playback after the DV tape is slightly rewind.(For DV devices that do not support the –1x speed, the rewinding timemay be longer.)C Sound monitor switchFor selecting the desired sound format for dubbing.1 Connect a camcorder or DV equipment to the [DV IN] connectoron the unit’s front panel.2 Press DV/HDD/DVD SELECT on the unit repeatedly; or pressHDD or DVD on the remote control to select the recording deck.● When dubbing to a DVD disc, load a recordable disc on thisunit.3 Press CH +/– to set the channel to ADVB.4 Press ON SCREEN.● The on-screen display for DV dubbing appears.5 Press selection keys to select , then press ENTERto display the remote icon (facing to the right) for the DVequipment.6 Press REC MODE repeatedly to set the recording mode. ForDV deck, press REC MODE on the remote control to set therecording mode.7 Locate the point from where you want to start dubbing, thenstop or pause playback by pressing the following buttons on theremote control: I, N, O, o, W.● To play back in slow speed (1/10 of the normal speed), press Wto pause playback, then press O or N.● To play back frame-by-frame, press W to pause playback, thenpress W repeatedly. Each press of W advances a frame.● To change the playback direction, press O or N.8 Press selection keys to select , then press ENTERrepeatedly until the desired sound track appears on the TVscreen.SOUND1:Select this to record the original stereo sound played back onthe connected DV equipment.SOUND2:Select this to record the dubbed stereo sound played back onthe connected DV equipment.MIX:Select this to record the sound of both ASOUND1B andASOUND2B.● Note that this selection is not available when the sourceprogram is recorded in 16BIT (48 kHz) mode.9 Press selection keys to select , then pressENTER. The dubbing starts.● Playback on the external DV equipment and recording on theunit should start simultaneously.DV Dubbing (HDD & DVD Deck Only)NOTES:● When connecting the unit to a device equipped with a DV inputconnector, be sure to use the optional DV cable (VC-VDV204U).● When you connect a PC to the [DV IN] connector, we do notassure the normal operation of this unit.To [DV IN]DV cable(VC-VDV 204U)(not supplied)CamcorderDV connectorYour unitDV equipmentL – RSOUND10:00 1:00 2:00 GR-DV3500GR-DV3500DVHDD00:00:00. 0012bit JVC00:00:00. 00DVFR360DV DV 1 2A B C