SW-2000M-CL-652NoticeThe material contained in this manual consists of information that is proprietary to JAI Oy,Finland and may only be used by the purchasers of the product. JAI Oy, Finland makes nowarranty for the use of its product and assumes no responsibility for any errors which mayappear or for damages resulting from the use of the information contained herein. JAI Oy,Finland reserves the right to make changes without notice.Company and product names mentioned in this manual are trademarks or registeredtrademarks of their respective owners.Warranty12 months from date of delivery, 4 months for repairs covering the work and parts at thefactory.CertificationsCE complianceAs defined by the Electromagnetic compatibility requirements of Directive 2004/108/EC of theEuropean Parliament and of the Council, JAI Oy, Finland, declares that SW-2000M-CL-65complies with the following provisions:EN 61000-6-2 (2005), EMC immunityEN 61000-6-4 (2007), EMC emissionsFCCThis equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiveris connected.- Consult the dealer or an experienced radio/TV technician for help.-WarningChanges or modifications to this unit not expressly approved by the partyresponsible for FCC compliance could void the user’s authority to operate theequipment.