Instructions for the user134. Using the cooking hobMake sure that the flame caps, the burner caps and the pan supports are fitted correctly.During normal operations, the appliance heats up considerably. Caution should therefore be used.Do not allow children to approach the appliance. Do not leave the cooking hob unattendedwhile it is on.4.1 Switching on the burnersAll the hob burner knobs have the following symbols:OFFhigh flamelow flameThe low flame setting is found by turning the knob anticlockwise all the way. All intermediatesettings must be selected between the high flame and low flame, never between high flame andclosed.4.1.1 One-touch lightingThe hob burners are equipped with a "one-touch" lighting system. To switch on one of the burners,press the knob corresponding to the required burner and turn it anticlockwise to the low setting .Hold down the knob to activate the automatic "one-touch" lighting system. When the burner is on,hold down the knob for approximately 10 seconds, to allow the safety valve to open. In the eventof a power cut, the burner can also be lit with a match (see section “4.1.2 Manual lighting”).Should the burner switch off accidentally, the safety thermocouple blocks the gas flow, even whenthe tap is open.The device should not been activated for longer than 15 seconds. If after that time it fails tooperate stop pressing the knob, open the window and wait 1 minute before trying again. In casethe flame goes out accidentally turn off the knob and do not try to switch on the burner for at least1 minute.4.1.2 Manual lightingTo light one of the burners, move a lit match towards the burner, press the corresponding knob andturn it anticlockwise to the minimum setting . Release the knob.4.2 Switching off the burnersAt the end of the cooking, return the knob to position .