Honeywell TUXWIFIS Installation And Setup Manual

Also see for TUXWIFIS: Installation and setup guide INSTALLATION GUIDE/USER GUIDE

Contents

Honeywell TUXWIFIS Installation And Setup Manual Manual pdf 47 page image

47Keypad Diagnostics and Calibration TestsKeypad TestsKeypad Test lets you verify correct operation of the Tuxedo and its connections to the security system.There are a total of five diagnostic tests;• LCD Display Test• Audio Test• LED Test• Calibration• Z-Wave TestPerforming Diagnostic TestsSelect any diagnostic test from the “Diagnostics” screen by pressing its associated Test icon. All or anyindividual test may be run when you access the “Diagnostics” screen; however, each test must beperformed one at a time. At any time when a test is not being performed, you can press back to return tothe previous screen, or home to return to your home page.Once the Diagnostics screen is exited, subsequent entry to this screen displays all test options as "NotPerformed."LCD Display TestFrom the "Home" screen, press the Setup > System setup > Advanced Setup icons.If applicable, enter your authorized code and press the Keypad Test icon.Press the icon for LCD Display Test ; a series of screens appear.After each type of display, you are asked if the display was proper. If the response to all questions is yes,the LCD Display Test message area of the Diagnostics screen displays “Passed.”Audio TestPress the icon for Audio Test ; "Testing.." is displayed while beeps sound from the speaker. At theconclusion of the test, a pop-up "Confirmation Window" is displayed with the question "Did you hearBeeping?"When you press Yes, "Passed" is displayed in the test status column on the "Diagnostics" screen.When you press No, "Failed" is displayed in the test status column on the "Diagnostics" screen.LED TestPress the icon for LED Test ; "Testing.." is displayed while the 3 LEDs light sequentially, top tobottom (red, green, yellow), 5 times.At the conclusion of the test, a pop-up "Confirmation Window" is displayed with the question "Did you seechasing LED pattern?"If you press Yes, "Passed" is displayed in the test status column on the "Diagnostics" screen.If you press No, "Failed" is displayed in the test status column on the "Diagnostics" screen.The Emergency screen cannot be accessed while running the LCD Display Test.