Honeywell LYNX Touch User Manual

Also see for LYNX Touch Security System: User guide Programming guide User guide Quick guide User guide

Contents

Honeywell LYNX Touch User Manual Manual pdf 57 page image

– 57 –USER FUNCTIONSUSER FUNCTIONSUSER FUNCTIONSUSER FUNCTIONSRemote Phone Control FeatureThe LYNX Touch Series is equipped with a remote interactive phone capability that permitsaccess to the security system from any off-site touch-tone telephone using all user codes. Thesystem will provide the appropriate voice messages and any system beeping soundsindicating the status of the security system over the phone line. (Refer to Summary ofAudible Notification for further information.) The following functions can be performed fromany remote touch-tone telephone:• Disarm the system.• Arm the system in STAY or AWAY mode.• Bypass zones.• Check system status.The remote access session will be aborted if:• A report must be sent.• Any local or wireless key entry is made.• User Code is not entered within eight (8) seconds of call pickup (during the“system…..system announcement).• No keys are depressed for a period of 15 seconds and while no announcement has beenmade by the system. Any remote key entry will, however extend this timeout back to 15seconds.It will not be possible to begin a remote access session if:• A report must be sent• The system is in any Test mode.• Panel is in shutdown mode (programmed by your installer).Using Remote Phone Control FeatureDial the controls’s phone number. If no answering machine is present, the control will pickup between 1 and 14 rings, depending on the number programmed by your installer and willperiodically announce “SYSTEM ENTER CODE”. If an answering machine is on thepremises, you need to dial the premises and hang up on the first ring. Wait at least five (5)seconds (but no more than 22 seconds) and dial the premises phone number again. Thecontrol will pick up and periodically announce “SYSTEM”.