Honeywell LYNX Touch User Manual

Also see for LYNX Touch Security System: User guide Programming guide User guide Quick guide User guide

Contents

Honeywell LYNX Touch User Manual Manual pdf 17 page image

❁ ➼ ❪ ❁SECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESSystem StatusBefore arming your system, all protected doors, windows, and other protection zones must beclosed or bypassed (see the BYPASSING PROTECTION section).READY LED: The green READY indicator on the control will be lit if the system is ready tobe armed. If blinking, the system is not ready.ß Þ à á ë ❀ ❖ ✽ ◗ ❖ ❆ P ● ✽ ● ● ❖ ❄ ❊ ❈ ■ ❈ ❘ ❆ P ❍ ❁ ✽ ❏ ● P ❆ ✽ ✾ P ❆ ■ P ❘ ❋ ✽ ❲ P ❈ ▲ P ❆ ✽ P ❈ ❈ ❄ ❅ ❈ ❍ ✽ ▲ ❄ ❈ ❋ ❉ ■ ◆ P ◗ ◗ ❆ ❄ ◗ ❆ ■ P ❏ ✽ ■ ❈ ❏ ❖ ✽❍ ❅ ❆ ❆ ✽ ❈ ❏ ● ❏ P ❏ ✽ ❄ ◆ ❏ ❖ ✽ ● ❉ ● ❏ ✽ ❑ ✿Depending on the current state of the system the following phrases may be heard:fire alarm [zone voice descriptors]carbon monoxide alarm [zone voice descriptors]alarm [zone voice descriptors]fire fault [zone voice descriptors]carbon monoxide fault [zone voice descriptors]fault [zone voice descriptors]low battery [zone voice descriptor]system low batterycheck systemAC losszones bypassedchimeVOLUME LEVEL: The volume level of system announcements can be increased or decreased. Refer tothe MESSAGE RECORDING/PLAYBACK section for the procedure.The READY LED will be lit steadily once all protection zones have been closed or bypassed.You may now arm the system.