OneStart

Menu

Handcell DAG1000 Series User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Page 40 preview
Page 41 preview
Page 42 preview
Page 43 preview
Page 44 preview
Page 45 preview
Page 46 preview
Page 47 preview
Page 48 preview
Page 49 preview
Page 50 preview
Page 51 preview
Page 52 preview
Page 53 preview
Page 54 preview
Contents
  1. Table Of Contents
  2. Table Of Contents
  3. Equipment Introduction
  4. power supply
  5. Voice and Fax parameters
  6. call hold
  7. Call Transfer
  8. way Conference
  9. Factory Reset
  10. Sending and Receiving Fax
  11. WEB Configuration
  12. Login WEB
  13. State and Statistics
  14. Registration Information
  15. Quick Setup Wizard
  16. VLAN Parameter
  17. Static Route Table
  18. SIP Server
  19. Port Configuration
  20. Advanced
  21. Media Parameter
  22. SIP Parameter
  23. Digit Map
  24. Feature Codec
  25. System Parameter
  26. Call & Routing
  27. IP Trunk
  28. Routing Configuration
  29. Tel-IP/Tel Routing
  30. Manipulation Configuration
  31. Tel-IP Caller
  32. Tel-IP Callee
  33. Firmware Upload
  34. Data Backup
  35. Tracert Test
  36. Password Modification
  37. Device Restart
  38. Glossary
Handcell DAG1000 Series User Manual Manual pdf 16 page image
DAG1000/2000 Series FXS Voice Gateway User Manual134.3 State and Statistics4.3.1 System InformationSystem information interface shows the run information as following figure 4.3.1 below:Figure 4.3-1 System InformationSystem information as follow:Table 4.3-1 System Information DescriptionMAC address WAN port hardware address. The device ID in HEX format.Network Mode Display network mode, include bridge and route. If it is bridge, WAN port displayNetwork, and the WAN port as same as the LAN port.Network Display WAN and LAN port IP address, subnet mask and the way of obtain IP address.WAN PortShows WAN IP address of DAG ,DHCP mode: all the field values for the Static IP mode are not used (even thoughthey are still saved in the Flash memory.) The DAG acquires its IP address from thefirst DHCP server it discovers from the LAN it is connected.Using the PPPoE feature: set the PPPoE account settings. The DAG willestablish aPPPoE session if any of the PPPoE fields is set.Static IP mode: configure the IP address, Subnet Mask, Default Router IP address,DNS Server 1 (primary), DNS Server 2 (secondary) fields. These fields are set to zeroby default.LAN Port Shows LAN IP address of DAG. if network Mode is bridge, LAN port won’t display.DNS Server Display DNS server IP address and default gateway informationSystem Uptime Time elapsed from device power on to now.Network TrafficStatics Total bytes of message received and sent by network port.Version Includes: product mode, software version, hardware version and built time etc.
/ 54
This manual is suitable for:
DAG1000 SeriesDAG2000 Series
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved