HAI omni iiE Installation Manual

Also see for OMNI IIe: Owner's manual Installation

Contents

HAI omni iiE Installation Manual Manual pdf 40 page image

Page 34INSTALLER SETUPThis section describes the items that the installer must setup as part of system installation. The Installer Setup mode is used toconfigure the general operation of the system, the Outputs, the Areas, the Zone Types, the Digital Communicator, and variousother settings. This information is covered only in this manual. All other SETUP items, including delay times, names and voices,voice dialer, and codes are covered in the Owner's Manual, Document No. 20R00-1.SETUP items are stored permanently in the system, even if the battery and AC power are disconnected. The "default" settings arethe ones that have been set at the factory. You can review or change the setup items easily, as shown below.Note: The default Installer Code is 1111.To access the SETUP menu, press the 9 key and enter the installer code. To access the INSTALLER SETUP menu, press the #(INST) key.INSTALLER SETUP MENU:1=CTRL 2=ZONE 3=DCM ↓4=AREA 5=TEMP 6=MISC7=EXP ↑SETUP CONTROLTo configure X-10, UPB, voltage outputs, and Vizia RF Z-Wave options, from the Installer Setup menu, select the 1 (CTRL) key.The output type for both the interior and exterior horns may also be changed.Press (Ø) to advance to the next item, (×) to go back.X-10 HOUSE CODEThe base X-10 house code must be specified. The base house code is the house code for units 1-16 and is referenced as housecode 1. The house code for the units 17-32 is the next house code after the base house code, or house code "B" if the base housecode is "A". House codes "C" and "D" follows for Units 33-64, respectively.X-10 HOUSE CODE: A1-16=A-P ↓UPB NETWORK IDThe Network ID is a unique number between 1 and 255 which identifies your UPB Network.UPB NETWORK ID: 11-255 ¦Enter the UPB Network ID (1-255) followed by the ' # ' key.UPB PASSWORD:The Network Password is a 4-digit number between 0001-FFFF that is used to protect your UPB network from unauthorizedchanges to the internal settings of your UPB devices.UPB PASSWORD: 12340000-FFFF ¦Enter the UPB Password (0000-FFFF) followed by the ' # ' key.To enter the digits A-F, first press the “OFF” key, then press the 0-5 key respectively (i.e. “1A2B” = 1 OFF 0 2 OFF 1 #).