54Step2 When the BootWare main menu appears again, select 0 to reboot the system.System is rebooting now.System start booting...Booting Normal Extend BootWare....Step3 Set a new password in system view after the system reboots. system-view[H3C] user-interface console 0[H3C-ui-console0] authentication-mode password[H3C-ui-console0] set authentication password simple 123456The output shows that the console port uses password authentication, and the password is set to 123456and stored in plain text.When you set the password by using the set authentication password { cipher | simple } passwordcommand, follow these guidelines.• If the cipher keyword is specified, the password is stored in cipher text. You cannot view thepassword by using the display current-configuration command.• If the simple keyword is specified, the password is stored in plain text. You can use the displaycurrent-configuration command to view the password in the current configuration.NOTE:• After the router reboots, the system runs with the initial default configuration, but the previousconfiguration file is still stored in the storage medium. To restore the previous configuration, use thedisplay saved-configuration command to display the configuration, and then copy and execute theconfiguration.• If the password is stored in plain text, you can use the display current-configuration command to viewthe password in the current configuration. If the password 123456 is set with the set authenticationpassword cipher command, the password is stored in cipher text.Step4 Save the new password.[H3C] saveNOTE:• To save the new password, execute the save command after modifying the user password.• H3C recommends saving the modification as the default configuration file.Super password lossThe super password enables you to switch between four super levels. In the case of super password loss,you cannot perform higher level operations.You can clear the super password by selecting 8 on the BootWare main menu.================================================|<1> Boot System ||<2> Enter Serial SubMenu ||<3> Enter Ethernet SubMenu ||<4> File Control ||<5> Modify BootWare Password ||<6> Skip Current System Configuration |
