H3C SR6602 Installation Manual

Also see for SR6602: Configuration guide

Contents

H3C SR6602 Installation Manual Manual pdf 24 page image

16Figure 16 Push the MIM into the slotStep3 Use a flat-blade screwdriver to fasten the captive screws on the MIM.Step4 Power on the router and check the status LED on the front panel. On means the MIM is installed correctlyand running properly. Off means the MIM has failed the POST.NOTE:HIMs are hot swappable and you must perform the remove slotnumber command to stop the modulebefore you remove it.Installing a CF cardFollow these steps to install a CF card:Step1 Make sure that the CF card status LED is not flashing.Step2 Push the CF card eject button all the way into the slot, and make sure that the button does not project fromthe panel.Step3 Insert the CF card into the slot following the direction shown in Figure 17, and make sure it does notproject from the slot.Figure 17 Insert the CF card into the slot