31CPLD Version : 135.0PCB Version : Ver.BBootWare Validating...Press Ctrl+B to enter extended boot menu...Starting to get the main application file--cfa0:/SR6602.bin!........................................................................The main application file is self-decompressing...........................................................................................................................................................Done!System is starting.....User interface con0 is available.Press ENTER to get started.Press Enter, and the following prompt appears:You can now configure the router.Logging in to the router through TelnetFollow these steps to log in to the router through Telnet:Step1 After powering on the router, log in to the router through the console port. Enable the Telnet function onthe router and set user privileges.Step2 Connect the PC to the management Ethernet interface on the router and specify an IP address for theinterface.Step3 Specify an IP address for the PC, make sure that the PC and the interface are in the same networksegment.NOTE:For more information about how to log in to the router, see theH3C SR6600 Routers ConfigurationGuides.Logging to the router through the AUX portFollow these steps to log in to the router through the AUX port:Step1 After powering on the router, connect the console cable to the console port, and configure the AUX portas follows:To do… Use the command…Enter system view system-viewEnter AUX user interface view user-interface aux 0
