Menu
Gearmore PDC400 Operation, Service & Parts Manual
                                    | |
Contents
| 
ATTENTION!Before use, please check that gears are adequately greased(see lubrication section)ATTENTION!During the use of the machine, please be sure that for a radius of 30yards there are not any persons or animals. If somebody comes up,please immediately stop the tractor engine.5.1 RECOMMENDATIONS FOR A CORRECT DISTRIBUTION:● Please always test the lbs. per acre that you wish to spread before starting to work.● Do not engage the PTO shaft when the tractor is in acceleration, because it will start thependulum spreading. Lower the engine revolutions at the minimum and after that speed upgradually till obtaining a speed of 540 r.p.m.● Open exits only when the right speed is achieved.● Avoid spreading fertilizer on windy days, in order to improve the uniformity of the distribution.5.2 SPREADING WIDTH ADJUSTMENT:The spreading angle can be reduced for narrow spreading. The spreader is set at the factory for the maxi-mum spreading angle of 56 degrees, position 1 for maximum spreading of 46 feet. You can reduce thedegrees to 48° for spreading as narrow as 9 feet. When the arrow on the adjuster points away from thedriveshaft, you achieve the widest angle. When the arrow points to the driveshaft, the spout will move tothe narrowest angle.For better accuracy in narrow rows, it is recommended that you purchase one of the narrow row spouts.5. FERTILIZER SPREADER USE15 |
Related manuals for Gearmore PDC400
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved