Gateway ALR 8300 Maintaining And Troubleshooting

Also see for ALR 8300: User guide

Contents

Gateway ALR 8300 Maintaining And Troubleshooting Manual pdf 115 page image

Appendix 103Regulatory compliance statementsFCC noticeThis device has been tested and found to comply with the limits for a Class Adigital device, pursuant to Part 15 of the FCC rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may causeharmful interference to radio or television reception. However, there is noguarantee that interference will not occur in a particular installation. If thisequipment does cause interference to radio and television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures:• Reorient or relocate the receiving antenna• Increase the separation between the equipment and receiver• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected• Consult the dealer or an experienced radio/TV technician for helpThis equipment has been tested and found to comply with the limits of a Class Adigital device. The accessories associated with this equipment are as follows:• Shielded video cable• Shielded power cordThese accessories are required to be used in order to ensure compliance with FCCrules.Industry Canada noticeThis digital apparatus does not exceed the Class A limits for radio noise emissionsfrom digital apparatus as set out in the radio interference regulations of IndustryCanada.Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant leslimites applicables aux appareils numériques de Classe A prescrites dans lerèglement sur le brouillage radioélectrique édicté par Industrie Canada.American UsersCanadian Users:Caution!The FederalCommunicationsCommission warns usersthat changes ormodifications to the unit notexpressly approved by theparty responsible forcompliance could void theuser’s authority to operatethe equipment.