GarrettCom Magnum 1016 Installation And User Manual

GarrettCom Magnum 1016 Installation And User Manual Manual pdf 8 page image

Magnum 1000 Workgroup Hubs Installation and User Guide (04/02)2www GarrettCom com. .Power Supply (Internal)AC Power Connector: IEC-type, male recessed, rear of chassisInput Voltage: 90 to 260 VAC (auto-ranging)Input Frequency: 47 to 63 Hz (auto-ranging)Power Consumption: 10 watts typical, 20 watts max. P.S. rating(For 48VDC power input option, see Appendix B).Agency ApprovalsUL Listed (UL 1950), cUL, CEEmissions meet FCC Part 15 Class AWarrantyThree years, return to factory Made in USA1.2 Specifications - Repeater Port Modules (RPMs)RPM Type : BNC AUI DTE Fiber-mm Fiber-sgl.m TP*Front Access yes yes yes yes yes yesConnector Type BNC-f DB-15 f DB-15 m Fiber-ST Fiber-ST RJ-45Partition (PART)LED yes yes yes yes yes yesReceive (RX) LED yes yes yes yes yes yesLINK LED n.a. n.a. n.a. yes yes yesSwitch on Face Plate yes** n.a. n.a. n.a. n.a.yes***ìFiber-mmî is multi-mode cable, normally used for 10BASE-FL installations, up to2.0Km.ìFiber-sgl.mî is single-mode cable, used for distant installations, up to 10.0Km.* The RJ-45 connector is shielded; it accepts RJ-45 eight-pin plugs for unshieldedand shielded twisted pair wiring.** Internal termination switch for BNC, no "T" connector is required.*** MDI-X (Media Dependent Interface - Crossover) switch for RJ-45 up-link,no crossover cable is required.1.3 Specifications - Bridge Port Modules (BPMs)BPM Type : BNC AUI Fiber TP*Connector Type BNC(f) DB-15(f) ST RJ-45Switch on FP yes** n.a. n.a. yes***FWD-I LED yes yes yes yesFWD-X LED yes yes yes yesLINK LED n.a. n.a. yes yes* The RJ-45 connector is shielded; it accepts RJ-45 eight-pin plugs for unshieldedand shielded twisted pair wiring.** Internal termination switch for BNC, no "T" connector is required.*** MDI-X (Media Dependent Interface - Crossover) switch for RJ-45 up-link,no crossover cable is required.