GarrettCom Magnum 1016 Installation And User Manual

GarrettCom Magnum 1016 Installation And User Manual Manual pdf 28 page image

Magnum 1000 Workgroup Hubs Installation and User Guide (04/02)22www GarrettCom com. .3.0 INSTALLATIONThis section gives instructions for installing the Magnum 1000 WorkgroupHubs, and for connecting the various Ethernet media.3.1 Table-Top or Rack-MountInstallation of a Magnum 1000 Workgroup Hub is a very simple procedure.Magnum hubs are easily mounted in a rack or on a table-top. When properly installed,the front-mounted LED status indicators should be in plain view and easy to read.Rack mountinginstallation requires aspecial rack-mountbracket. (This isincluded with models1016 and 1024. Formodel 1008, order part #1008-RMB.) Thebrackets easily attach tothe hub, which is theninstalled in any standard 19 inch rack. Figure 3.1: Magnum 1000ís,Rack-mount Brackets3.2 Powering the Magnum 1000 Workgroup HubMagnum 1000 Workgroup Hubs incorporate an internal universal powersupply, and have a recessed male IEC connector for the AC power cord at the right-rear.A six-foot 115 VAC 60 Hz power cord is supplied with each unit shipped within theUnited states and Canada.Each Magnum 1000 Workgroup Hubís auto-ranging power supply supportsinstallation environments where the AC voltage is from 90 to 260 volts with a powerinput frequency between 47 and 63 Hz, and will consume a maximum of 20 watts(estimated). In order to power down the unit, simply unplug either end of the powercable.When connecting various Ethernet media, there is no need to power down theunit. Individual segments of any media type can be connected or disconnected withoutconcern for AC power-related problems or damage to the unit.1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24GARRETTMagnum 1000Workgroup Hub1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16GARRETTMagnum 1000Workgroup HubMagnum 1016 and 1024 Workgroup HubsRack Mount Brackets (Included)GARRETTMagnum 1000Workgroup HubMagnum 1008 Workgroup HubRack Mount Brackets (Optional)