Garmin Personal Navigator GPS 100AVD Owner's Manual

Also see for Personal Navigator GPS 100AVD: Installation manual

Contents

Garmin Personal Navigator GPS 100AVD Owner's Manual Manual pdf 57 page image

9-2· The speed field will display your present speed. You may enter adifferent speed to calculate time requirements.The GPS 100 will display the distance and bearing between the twogeographical points. In addition, the time requirement will be displayedbased on speed. Use the cyclic field to select estimated time enroute (ETE)or estimated time of arrival (ETA).To perform trip planning for a programmed route...• Use the CLR key to select the desired route as illustrated below. (Thewaypoint/route selection field will cycle through all programmedroutes containing 2 or more waypoints, i.e., RT0 to RT9.)Total/LegSelection• The first and last waypoints, total distance, and ETA/ETE informationwill be displayed for the entire route, as indicated by “TTL”.• To display the distance, bearing, and ETA/ETE information for eachindividual leg, use the CLR key to change from “TTL” to the desiredleg. (The leg field will cycle through every programmed leg, i.e., LG1to LG8, and the route total, TTL.)9.2 FUEL PLANNINGWaypoint/Route Selection From Waypoint To WaypointSpeed TimeFuel Flow Fuel RequiredFUEL PLANNING PAGEThe Fuel Planning Page allows you to calculate fuel requirements for anyroute you have programmed or between any two waypoints.