Introduction2MaintenanceCaring for your StreetPilotCleaning the Case and Remote ControlThe StreetPilot 2610/2650 case and remote are constructed of high quality materials and do not requireuser maintenance other than cleaning. Clean the unit’s outer casing (except for the touchscreen) using acloth dampened with a mild detergent solution and then wipe dry. Avoid chemical cleaners and solventsthat may damage plastic components.Cleaning the TouchscreenThe StreetPilot 2610/2650 touchscreen is intended primarily for finger operation. Although a PDA stylusmay also be used to operate touchscreen, never attempt this while operating a vehicle. Never use a hard orsharp object to operate the touchscreen or damage may result. The touchscreen should be cleaned using asoft, clean, lint-free cloth. Water, isopropyl alcohol, or eyeglass cleaner can be used if needed. If these areused, apply the liquid to the cloth and then gently wipe the touchscreen with the moistened cloth.StorageDo not store the StreetPilot 2610/2650 where prolonged exposure to temperature extremes may occur(such as in the trunk of a car) as permanent damage may result. User information such as waypoints androutes are retained in the unit’s memory without the need for external power. Back up important user databy manually recording it or downloading it to a PC (transferring it to MapSource).Storing alkaline batteries in the remote control for extended periods is not recommended. In order toreduce the chance for battery leakage in the battery compartment, remove the batteries when storing theremote control for more than six months.