GE Profile P2B918SEMSS Owner's Manual & Installation Instructions

Also see for P2B918: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions

39Read these instructions completely and carefully.Installation of the range.BEFORE YOU BEGINInstallation of this range must conform with local codes, or in the absence of local codes,with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. This range has beendesign-certified by CSA International according to ANSI Z21.1, latest edition.As with any appliance using gas and generatingheat, there are certain safety precautions you shouldfollow. You will find these precautions in the ImportantSafety Information section in the front of this manual.Read them carefully.IMPORTANT: OBSERVE ALL GOVERNING CODESAND ORDINANCES.NOTE: This appliance must be properly grounded.IMPORTANT: Save these instructions for the localelectrical inspector’s use.NOTE TO INSTALLER: Leave these instructions with theappliance after installation is completed.NOTE TO CONSUMER: Keep this Owner’s Manual andInstallation Instructions for future use.SERVICER: The electrical diagram is in an envelopeattached to the back of the range.FOR YOUR SAFETYDo not store or use combustible materials, gasoline or other flammable vapors and liquids in thevicinity of this or any other appliance.If you smell gas:Open windows.Don’t touch electrical switches.Extinguish any open flame.Immediately call your gas supplier.CAUTION: FOR PERSONAL SAFETY,DO NOT USE AN EXTENSION CORD WITH THISAPPLIANCE. REMOVE HOUSE FUSE OR OPENCIRCUIT BREAKER BEFORE BEGINNINGINSTALLATION.This appliance must be supplied with the propervoltage and frequency, and connected to anindividual, properly grounded circuit, protectedby a circuit breaker or time-delay fuse, as notedon the rating plate.Wiring must conform to National Electrical Codes.If the electric service provided does not meet theabove specifications, have a licensed electrician installan approved outlet.Because range terminals are not accessible afterrange is in position, flexible service conduit or cordmust be used.ELECTRICAL REQUIREMENTS■ This product must be installed by a licensedplumber or gas fitter.■ When using ball type gas shut-off valves, theyshall be the T-handle type.■ A flexible gas connector, when used, must notexceed 3 feet.IN THE COMMONWEALTH OF MASSACHUSETTSConsumer SupportOperating InstructionsSafety Instructions InstallationInstructions Troubleshooting Tips